LOG all - anywhere anywhere limit: avg 1/sec burst 5 LOG level info prefix `AIF:Dropped INPUT packet: 'īASE_FORWARD_CHAIN all - anywhere anywhere Here is output from iptables –L right after boot:įail2ban-COURIER tcp - anywhere anywhere tcp dpt:smtpįail2ban-VSFTPD tcp - anywhere anywhere tcp dpt:ftpįail2ban-SSH tcp - anywhere anywhere tcp dpt:sshīASE_INPUT_CHAIN all - anywhere anywhereĮXT_INPUT_CHAIN !icmp - anywhere anywhere state NEWĮXT_INPUT_CHAIN icmp - anywhere anywhere state NEW limit: avg 60/sec burst 100ĮXT_ICMP_FLOOD_CHAIN icmp - anywhere anywhere state NEW P600 tps # /etc/init.d/arno-iptables-firewall start To test a bit further I recompiled as much netfilter stuff as possible as modules and now I only have one warning when I manually start Arno's Iptables Firewall: I believe these features are compiled into the kernel.

Posted: Sun 7:53 am Post subject: Masquerading only works after manual start of Arno's Iptable Last edited by tps on Sun 9:19 pm edited 1 time in totalĪre those features compiled into the kernel? Do the rules actually load or is the script mistaken when it says it was successful? What can I do to make Arno's Iptables Firewall start at boot? Perhaps the same warnings count for the warnings I have in the /var/log/messges show above? sbin/modprobe ip_conntrack_ftp: Module not found! Assuming compiled-in-kernel! sbin/modprobe ip_conntrack: Module not found! Assuming compiled-in-kernel! sbin/modprobe ip_tables: Module not found! Assuming compiled-in-kernel! P600 ~ # /etc/init.d/arno-iptables-firewall startĪug 28 10:21:25 All firewall rules applied. I hope that is not too much of a risk:Įverything is ok if I start Arno's Iptables Firewall manually: I have this line in /etc/portage/package.keywords to let emerge install Arno's Iptables Firewall. Here is what I have in /var/log/messages:Īug 28 07:49:53 p600 syslog-ng: syslog-ng shutting down version='3.1.1'Īug 28 07:51:12 p600 syslog-ng: syslog-ng starting up version='3.1.1'Īug 28 07:51:14 p600 firewall: ** Starting Arno's Iptables Firewall v1.9.2d **Īug 28 07:51:51 p600 firewall: ** WARNING: Not all firewall rules are applied **Īug 28 07:51:51 p600 rc-scripts: WARNING: Failed to load FirewallĪug 28 07:51:55 p600 dhcpcd: eth0: dhcpcd 4.0.15 startingĪug 28 07:51:55 p600 dhcpcd: eth0: broadcasting for a lease The other day I booted my host and I noticed that Arno's Iptables Firewall did not start. I am very happy with gentoo and Arno's Iptables Firewall. Posted: Sat 8:27 am Post subject: Arno's Iptables Firewall does not start at boot Gentoo Forums Forum Index Networking & Security Arno's Iptables Firewall does not start at boot

Gentoo Forums :: View topic - Arno's Iptables Firewall does not start at boot

Arno iptables firewall